Table of Contents
Advertisement
Maintenance
Controller Maintenance
ating system is fully loaded. You may then continue your work with the
system.
In some cases the boot device cannot be found after accepting a con-
figuration. Then you have to specify the boot device in the BIOS of the
RAID. To access the RAID BIOS press [Ctrl + H] at the indicated moment
during the start-up of the system. The setting can be found after select-
ing the respective controller and switching to 'Virtual Drives'.
If the newly installed controller module cannot be detected by the sys-
tem or you see a system message indicating a degraded RAID array,
please contact the R&S DVS service department.
5-18
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH
Advertisement
Table of Contents
