R&S SpycerBox Cell Hardware Manual page 54

Maintenance
 Controller Maintenance
Step 2: Reassembling the controller module into the system
After receiving the new controller module from the R&S DVS service
department, you can reassemble it into the system. Perform the follow-
ing:
Other spare parts
Others than the original manufacturer spare parts might damage
your system.
Only use original manufacturer spare parts.
1. Cautiously slide the new controller module back into its shaft as in
the following figure:
Push the anchoring up and fix the locking screws manually.
2.
It is generally recommended to fix the locking screws manually with
your fingers as you could overtighten the screws with a screwdriver.
5-16
Figure 5-10: Sliding back the controller module
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH