R&S SpycerBox Cell Hardware Manual page 44

Maintenance
 Hard Disk Maintenance
Step 1: Removing the Hard Disk
The hard disks that are accessible on the hard disk trays are connected
to the system with the help of disk carriers. They can be removed easily,
even when the system is running (hot-swappable).
For an overview of a disk carrier as well as further information about it
see section "Hard Disk Tray" on page 2-6.
Do not remove any components from the system until you have the re-
spective spare part(s) at hand.
Wrong disk replaced
Replacing the wrong hard disk, i.e. a good one instead of the bro-
ken one, may result in a total loss of data.
If you are not sure about having detected the correct hard
disk please contact the R&S DVS service department.
To remove a hard disk from the system, perform the following:
Move the lever of the disk carrier of the defective hard disk up as
1.
shown in the following figure:
2. Use the lever to cautiously pull the disk carrier out of the system.
For this take the lever, pull the disk carrier cautiously to your direc-
tion, when standing right in front of the system, and then pull it
cautiously up and out as shown in the following figure:
5-6
Figure 5-2: Moving up the lever
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH