Shutting Down The System - R&S SpycerBox Cell Hardware Manual

Operation


Shutting Down the System

Additionally, you can reboot or shut down the R&S DVS system with
SAN Remo.
For a complete description of the features of SAN Remo and how to use
it, refer to the "SAN Remo Configuration Management" supplement.
4.3 Shutting Down the System
There are several possibilities to shut down the R&S DVS system. All
depend on whether the operating system is already loaded, frozen or
not completely loaded. Please act accordingly.
To shut down the system, perform the following according to the state
of the system's operating system:
After a shut-down wait at least ten seconds before starting the system
again. This time is needed to safely erase all memory banks of the sys-
tem.
With the operating system fully loaded
If the operating system is up and running, there are two ways to shut
down your system:

Turn the system off by shutting down the operating system the
usual way (see also section "R&S DVS SAN Remo" on page 4-3 and
section "R&S DVS SAN Remo" on page 4-3).
The operating system will then save your personal settings and once it
has ended, the system will turn off.
Alternatively, you can initiate a fast shut down by pressing the power
switch briefly.
Fast shut down (emergency shut down)
The fast shut down may not save all your system data and personal
settings before the system turns off.
Save all data and settings before shutting down the system.
Some settings will be saved and afterwards the system turns off.
4-4
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH