Table of Contents
Advertisement
Operation
Starting the System
4.1 Starting the System
After a proper installation of the system (see chapter "Installation" on
page 3-1) you may start the R&S DVS system at any time.
To start the system perform the following:
Press the power switch at the right side of the faceplate (see sec-
tion "Faceplate" on page 2-4) briefly to turn on the system.
The system will be started and the R&S DVS logo in the middle of the
faceplate lights up. As with any standard computer after initial booting,
the system begins to load the installed operating system.
During the start-up of the system several alarm beeps will be sounded.
This is part of a self-test and does not indicate an error or malfunction.
When the operating system has finished its loading, you can begin to
work with the R&S DVS system right away.
Additionally, the R&S DVS configuration management software
SAN Remo is described briefly which allows you to configure, reboot
and shut down the SpycerBox Cell.
4-2
power switch
SpycerBox Cell | Hardware Guide | Version 1.0
Figure 4-1: The power switch
Rohde & Schwarz DVS GmbH
Advertisement
Table of Contents
