Table of Contents
Advertisement
Maintenance
Power Supply Maintenance
Then pull the unit at its handle out of the power supply.
4.
Change the power supply unit against a new and operable one.
5.
Other spare parts
Others than the original manufacturer spare parts might damage
your system.
Only use original manufacturer spare parts.
Slide the new unit into the power supply until it clicks into place.
6.
Power supply unit turned
When sliding in the new power supply unit in a wrong rotation, the
system might be damaged.
Please regard the correct position and rotation of the power
supply unit (LED on the upside).
When completely inserted, please observe that the latch is truly in place
and locking the unit.
Connect the power source (power cord) to the newly installed
7.
power supply unit.
8.
After that check the LED indicating the status of the power supply
unit: If it is lit up in green, the unit is working properly.
With this the power supply unit has been replaced successfully.
5-20
High voltages
The system you are working on operates with voltages that
can be hazardous to your health.
Do not reach inside the system when removing a
power supply unit or when the unit is out of the sys-
tem.
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH
Advertisement
Table of Contents
