Replacing A Hard Disk - R&S SpycerBox Cell Hardware Manual

You can configure SNMP or use the SAN Remo configuration manage-
ment software to monitor the hardware parts of the SpycerBox Cell as
well. For this, see the „SAN Remo Configuration Management" supple-
ment.
If the first hard disk tray does not contain any broken hard disk, slide it
back into the system and pull the second hard disk tray out.
Once the broken disk has been identified, you can replace it as de-
scribed in section "Replacing a Hard Disk" on page 5-5.

5.1.3 Replacing a Hard Disk

As soon as the broken hard disk has been identified (see section "Iden-
tifying a Broken Hard Disk" on page 5-4), it can be replaced easily. For
this you have to contact the R&S DVS service department or your local
R&S DVS contact person to order a new hard disk for the replacement.
Second disk fail
If you do not replace a broken disk in time and another disk fails in
the meantime, your data may be unrecoverable.
Replace a broken hard disk as soon as possible.
Before replacing a hard disk, you have to gather the log files of the RAID
controller. If you know how to do this you may proceed on your own. If
not, please contact the R&S DVS service department first.
The replacement of a broken hard disk can be divided into two steps:
1. Removing the hard disk from the system.
2. Reassembling it into the system.
Depending on your service contract, different scenarios regarding spare
parts are possible:

You have ordered spare parts together with the system and have
them now available in stock

R&S DVS sends you the new spare parts before you send back the
hardware part you want to replace (advanced replacement)

You first send the hardware part you want to replace and then
receive the new one from R&S DVS
Please refer to the R&S DVS service department for further information
about this.
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH
Maintenance
 Hard Disk Maintenance
5-5