Table of Contents
Advertisement
Display
The following shows a typical display sample.
Measuring
with Unit
Measuring Value with Unit
Measuring Range and Mode
Status of the Digital Inputs / Outputs
Lifesign
Status Signal
Error Message
Page 24 / 92
Lifesign
Value
Measuring Range
and Mode
Figure 12 Display
Output of the actual measuring value with the correspond-
ing physical unit. With range overflow the message −OL− is
issued.
Output of the actual measuring range, physical unit and
measuring mode.
The actual state of the digital inputs and outputs is perma-
nently issued:
An active input or output is shown invertedly.
For easy evaluation of the functioning, this field flashes
once per second.
This shows e.g. an active LAN access.
This message appears, if an internal error or an interface
error has been detected.
The detailed error states can be queried via the interfaces
or the set-up menu.
Gaussmeter IGM11 Operating Instructions
Status Signal
Status of the Digital
Inputs- / Outputs
on the left: inputs 1 to 3
on the right: outputs 1 to 4
Chapter 5 Operation
Error Message
Advertisement
Table of Contents
