Table of Contents
Advertisement
8-6. Condensation custom pattern
<Figure: Example of the
condensation custom>
8-6-1. Selecting the condensation custom
Select condensation custom pattern referring to
49.
The condensation custom pattern for reverse-feed stitching at the end of sewing can be set in the similar
manner.
8-6-2. Creating a new condensation custom
A new condensation custom pattern creation procedure is described as follows using <Figure: Example of
the condensation custom> as an example.
① Selecting the condensation custom pattern setting on the mode screen
<Mode screen>
Condensation stitches can be sewn while specifying needle
entry points as desired, by setting a condensation custom.
Condensation
As many as 64 stitches can be created.
custom
As many as 20 patterns can be registered.
"5-2-3. (2) ◆ In the case of maintenance personnel mode" p.
1. With some combinations of stitch length, di-
rection of feed and sewing speed, the sewing
machine may fail to finish a sewing pattern
exactly according to the settings.
2. Needle cannot be entered to the same needle
entry point when the stitch length is set to 0.0
mm.
3. In the case the stitch length differs between
the normal feed and the reverse feed, correct
the stitch length appropriately with the memo-
ry switch K330 (normal direction stitch length
correction) and K331 (reverse direction stitch
length correction).
❶
1) Press
The "mode screen" is displayed.
2) Select the "5. Condensation custom sewing
setting".
The "condensation custom pattern list screen"
is displayed.
– 165 –
❶ .
Advertisement
Table of Contents
