Table of Contents
Advertisement
No.
U038 Speed during one-shot stitching
The maximum number of revolutions during soft start differs with the machine
head.
U039 Start position of rotation
Set start position from neutral pedal position. (Pedal Stroke)
U040 Start position of acceleration
Set accelerating position from neutral pedal position. (Pedal Stroke)
U041 Start position of lifting of presser foot
Set work clamp lift position from neutral pedal position. (Pedal Stroke)
U042 Start position of lowering of presser foot
Set work clamp fall position from neutral pedal position. (Pedal Stroke)
U043 Start position of thread trimming
Set thread trimming starting position from neutral pedal position. (Pedal Stroke)
U044 Position that maximum sewing speed is reached
Set maximum speed reaching position from neutral pedal position. (Pedal Stroke)
U045 Pedal neutral-position correction value
Set neutral position of pedal sensor.
U047 Presser-foot lift finishing position
The position to which the presser foot goes up when the back part of the pedal is
depressed to its first step. (1st-step spring position)
U048 Function of lifting the presser foot by depressing the pedal
Whether or not the presser-foot lifting operation is carried out by depressing the
back part of pedal is set.
0: No operation / 1: Operation
U049 Presser foot lowering time
The initial value differs depending on the machine head.
U051 Correction of turning-ON of reverse feed stitching (at start)
U052 Correction of turning-OFF of reverse feed stitching (at start)
U053 Correction of turning-OFF of reverse feed stitching (at end)
U054 Standby time until the presser foot starts going up
Time to be elapsed from the moment the pedal is depressed to the 1st step to the
moment the presser foot starts going up.
U056 Reverse-rotation needle-up after thread trimming
The initial value differs with the machine head.
0: Reverse-rotation needle-up is not performed / 1: Reverse-rotation needle-up is
performed
U057 Feed dog position at thread trimming
The feed dog height is fixed to 0 (zero) at the time of thread trimming.
0: Not fixed / 1: Fixed
U059 Selection of revere feed stitching (at start) operation
0: By manually operating the pedal, etc. / 1: According to the preset reverse feed
sewing speed
U060 Stop after reverse feed stitching (at start)
The stop function stops the sewing machine temporarily regardless of the operat-
ing status of the pedal.
0: OFF / 1: ON
U064 Sewing-end reverse feed stitching, changeover speed
Item
– 110 –
Setting range
Unit
100 to 5000
sti/min
ー
10 to 1000
ー
10 to 1000
ー
-500 to -10
ー
10 to 500
ー
-1000 to -100
ー
10 to 15000
ー
-150 to 150
ー
-1000 to -100
ー
0 to 1
0 to 500
ms
-50 to 50
Degree
-50 to 50
Degree
-50 to 50
Degree
0 to 200
ms
ー
0 to 1
ー
0 to 1
ー
0 to 1
ー
0 to 1
150 to 1000
sti/min
Advertisement
Table of Contents
