Figure 13: System Status Leds 5 Minutes After Power On - Mellanox Technologies TX6000 Hardware User Manual

Plug in the second power cable.
Step 2.
Wait for the system upload process.
Step 3.
Check the System Status LEDs and confirm that all of the LEDs show status lights consistent
Step 4.
with normal operation, as shown in Figure 13 below. For more information, refer to "LEDs" on
page 30.
19 Mellanox Technologies
It may take up to five minutes to turn on the system. If the System Status LED shows
red after five minutes, unplug the system and call your Mellanox representative for
assistance.

Figure 13: System Status LEDs 5 Minutes After Power On

System with 1 PSU
System with 2 PSUs
Installation