Fujitsu ETERNUS AF Series Configuration Manual page 17
All-flash arrays, hybrid storage systems, disk storage systems, power synchronized unit
Hide thumbs
Also See for ETERNUS AF Series:
- Configuration manual (16 pages) ,
- Configuration manual (38 pages) ,
- Safety precautions (12 pages)
Table of Contents
Advertisement
Safety Precautions
CAUTION
■ Instructions for rack installation
CAUTION
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Do Not
•
When the power synchronized unit is pulled out from the rack, make sure not to
hit your head if you are operating devices under the power synchronized unit. Not
doing so may cause injury.
•
Do not put your finger into the inlet/outlet. Doing so may cause injury or device
failure.
•
Do not remove the cover from the power synchronized unit inlet/outlet unless
necessary. Doing so may cause device failure.
•
Do not use devices such as mobile phones that emit radiation in the vicinity of
the power synchronized unit. Doing so may cause malfunction.
Do
•
Before applying insecticides for pest control, turn off the power synchronized unit
and cover it with a plastic sheet. Not doing so may damage the power synchro-
nized unit.
•
Note the following points when cleaning the power synchronized unit. Failure to
do so may cause device failure.
-
Make sure the power synchronized unit is turned off.
-
Do not allow liquids such as cleaner to get into the power synchronized unit.
-
Never use organic solvents such as alcohol or thinner to clean the power syn-
chronized unit.
Do
•
Especially for an enclosed rack with doors, or when multiple devices are to be
mounted and running, it is important to realize that the temperature inside the
cabinet will be considerably higher than that of the room. Make sure the rack
internal ambient temperatures do not exceed the environmental conditions for
temperature described in
the power synchronized unit.
•
When installing the power synchronized unit with other devices into the same
rack, the airflow of the device installed on and under the power synchronized unit
may interfere with each other and reduce the effect of device cooling. Make sure
to leave plenty of room between the devices if required. Failure to do so may dam-
age the power synchronized unit and lead to malfunction.
17
Copyright 2019 FUJITSU LIMITED
"Specifications" (page
22). Failure to do so may damage
P3AM-8012-14ENZ0
Advertisement
Table of Contents
