HPE ProLiant DL20 Gen10 User Manual page 50

b. Using a browser, navigate to the iLO web interface, and then log in. The web interface can be accessed by entering the iLO
hostname or IP address in the following format:
https://<iLO hostname or IP address>
NOTE: NOTE:
The iLO hostname is located on the serial number/iLO information label located on the top of the chassis.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If assigned, use the static IP address.
The default login credentials are located on the serial number/iLO information pull tab.
c. In the navigation pane, click Remote Console & Media, and then launch a remote console.
Power on the server Power on the server
5. Press the Power On/Standby button. For remote management, use the iLO virtual power button.
6. Using the SPP, update the following:
System ROM
Storage controller
Network adapters
Intelligent Provisioning
Set up the storage Set up the storage
7. Set up the storage. Do one of the following:
To configure the server to boot from a SAN, see the following guide:
https://www.hpe.com/info/boot-from-san-config-guide https://www.hpe.com/info/boot-from-san-config-guide
If an HPE Smart Array SR controller is installed, use the HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator.
If no controller option is installed, do one of the following:
AHCI is enabled by default. You can deploy an OS or virtualization software.
Disable AHCI, enable software RAID, and then create an array:
a. From the boot screen, press F9 to run UEFI System Utilities.
b. From the UEFI System Utilities screen, select System Configurations > BIOS/Platform Configuration (RBSU) > Storage
Options > SATA Controller Options > Embedded SATA Configuration > Smart Array SW RAID Support .
c. Enable Smart Array SW RAID Support .
d. Save the configuration and reboot the server.
e. Create an array:
i. From the boot screen, press F9 to run UEFI System Utilities.
ii. From the UEFI System Utilities screen, select System Configuration > Embedded Storage: HPE Smart Storage S100i SR
Gen10 > Array Configuration > Create Array.
Deploy an OS or virtualization software Deploy an OS or virtualization software
8. Deploy an OS or virtualization software. Do one of the following:
Press F10 at the POST screen.
For Intelligent Provisioning 3.30 and later, you are prompted to select whether you want to enter the Intelligent Provisioning or
HPE Rapid Setup Software mode. After you have selected a mode, you must reprovision the server to change the mode that
launches when you boot to F10.
Setting up the server 50