Seagate RealStor 5005 Series Hardware Installation page 79

7. Grasp the latch and the side of the PCM handle between thumb and fore-finger, squeeze together and open the
handle to cam the PCM out of the enclosure as shown in
Figure 43 Removing a PCM (1 of 2)
8. Grip the handle and withdraw the PCM, taking care to support the base of the module with both hands as you remove
it from the enclosure as shown in
Figure 44 Removing a PCM (2 of 2)
NOTE: The remove PCM illustrations show a chassis configured as a 4-port SAS controller enclosure, The
procedure applies to all 2U controller enclosures and expansion enclosures.
9. If replacing two PCMs, repeat steps 5 through 8, being mindful of the illustrations TIP on
Figure
Figure 44.
43.
1
2
page
Replacing a power cooling module
78.
79