Rackmount Rail Kit; Installing The 2U Enclosure - Seagate RealStor 5005 Series Hardware Installation

• The rack should cause a maximum back pressure of 5 pascals (0.5 mm water gauge).
• Before you begin, ensure that you have adequate clearance in front of the rack for installing the rails.

Rackmount rail kit

Various sets of rack mounting rails are available for use in 19-inch rack cabinets. These rails have been designed and
tested for the maximum enclosure weight, and to make sure that multiple enclosures may be installed without loss of
space within the rack. Use of other mounting hardware may cause some loss of rack space.
Contact your supplier to make sure suitable mounting rails are available for the rack you are to use.

Installing the 2U enclosure

1. Remove the rack mounting rail kit from the accessories box, and examine for damage.
2. Use the procedure below to attach the rail kit brackets to the rack post as shown in
a. Set the location pin at the rear of the rail into a rear rack post hole. Attach the bracket to the rear rack post: use
the washers and screws supplied. Leave the screws loose.
b. Extend the rail to fit between the front and rear rack posts.
c. Attach the bracket to the front rack post using the washers and screws supplied. Leave the screws loose.
d. Tighten the two clamping screws located along the inside of the rear section of the rack bracket.
e. Repeat the above sequence of steps for the companion rail.
Figure 28 Securing brackets to the rail (left hand rail shown)
3. Install the enclosure into the rack:
a. Lift the enclosure and align it with the installed rack rails, taking care to ensure that the enclosure remains level.
b. Carefully insert the chassis slides into the rack rails and push fully in.
c. Tighten the mounting screws in the rear rail kit brackets.
38 Installation
Illustration is under construction
Figure 28.