Using The Anti-Tamper Locks; Installing A Lff Drive Carrier Module (2 Of 2) - Seagate RealStor 5005 Series Hardware Installation

4. Cam the drive carrier home. The camming foot on the carrier will engage into a slot in the enclosure. Continue to push
firmly until the handle fully engages. You should hear a click as the latch handle engages and holds the handle closed.
Figure 49 Installing a LFF drive carrier module (2 of 2)
5. Using the management interfaces (the SMC or CLI), verify whether the health of the new disk is OK. Verify that the
Green Drive LED is on/blinking per

Using the anti-tamper locks

The LFF and SFF disk drive modules provide anti-tamper locks. Please refer to
1. Carefully put the T10 lock key into the cutout in the handle.
The LFF disk module is shown in the example below. On SFF disk modules, the socket is located between the latch
and the carrier handle as shown in
2. Position the key into its socket.
3. Perform one of the following actions to either activate or deactivate the anti-tamper lock:
Lock: Rotate the key in a clockwise direction until the indicator is visible in the aperture beside the key.

Unlock: Rotate the key in a counterclockwise direction until the indicator is visible in the aperture beside the key.

4. Remove the T10 lock key.
Indicator aperture (top detail at right)
Figure 50 Activating the anti-tamper lock
Figure 41 (page
Figure 41 (page
Locked
59). Verify that Ops panel states show no amber module faults.
Figure 50
59). The lock socket mechanism is identical on both modules.
when using this procedure.
Anti-tamper lock (bottom detail at left)
Unlocked
Replacing a drive carrier module 83