Terminal Emulator Display Settings; Terminal Emulator Connection Settings - Seagate RealStor 5005 Series Hardware Installation

Within the illustration below, the IOM is aligned for use in the bottom (0B) controller module slot.
Figure 36 Connecting a USB cable to the CLI port
3. Enable the CLI port for subsequent communication:
Linux customers should enter the command syntax provided in

(page 103).
Windows customers should locate the downloaded device driver described in

(page 102), and follow the instructions provided for proper installation.
4. Start and configure a terminal emulator, such as HyperTerminal or VT-100, using the display settings used in
(page 49), and the connection settings in
Table 10 Terminal emulator display settings
Parameter
Terminal emulation mode
Font
Translations
Columns
Table 11 Terminal emulator connection settings
Parameter
Connector
Baud rate
Data bits
Parity
Stop bits
Flow control
1-Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2-Verify the appropriate COM port for use with the CLI.
5. In the terminal emulator, connect to controller A.
6. Press Enter to display the CLI prompt (#).
The CLI displays the system version, Management Controller version, and login prompt.
a. At the login prompt, enter the default user manage.
Table 11 (page 49) (also, see the note following this procedure).
Value
VT-100 or ANSI (for color support)
Terminal
None
80
Value
1,2
COM3 (for example)
115,200
8
None
1
None
"Setting parameters for the device driver"
"Obtaining the software download"
Obtaining IP values
Table 10
49