Cusb Device Connection; Rear Panel Usb Ports; Usb Cli Port; Emulated Serial Port - Seagate RealStor 5005 Series Hardware Installation

Hide thumbs Also See for RealStor 5005 Series:
Table of Contents

Advertisement

C
USB device connection

Rear panel USB ports

RealStor 5005/4005 Series controllers contain a USB (Universal Serial Bus) Device interface pertaining to the
Management Controller (MC). The Device interface is accessed via a port on the controller module face plate. This
appendix describes the USB Type B port labeled CLI, which enables direct connection between a management computer
and the controller, using the command-line interface and appropriate cable.

USB CLI port

Connect USB cable to CLI port
on the canister face plate
Figure 57 USB device connection—CLI port
5005/4005 Series controllers feature a USB CLI port used to cable directly to the controller and initially set IP addresses,
or perform other configuration tasks. The USB CLI port employs a mini-USB Type B form factor, and requires a specific
cable and additional support, so that a server or other computer running a Linux or Windows operating system can
recognize the controller enclosure as a connected device. Without this support, the computer might not recognize that a
new device is connected, or might not be able to communicate with it.
For Linux computers, no new driver files are needed, but a Linux configuration file must be created or modified. See also
"Setting parameters for the device driver" (page
gserial.inf
the controller's CLI port. See also

Emulated serial port

Once attached to the controller module, the management computer should detect a new USB device. Using the Emulated
Serial Port interface, the 5005/4005 Series controller presents a single serial port using a customer vendor ID and
product ID. Effective presentation of the emulated serial port assumes the management computer previously had
terminal emulator installed. See also
IMPORTANT: Certain operating systems require a device driver or special mode of operation to enable proper
functioning of the USB CLI port. See also
, must be downloaded from a CD or web site, and installed on the computer that will be cabled directly to
"Microsoft Windows" (page
"Supported host applications" (page
"Device driver/special operation mode" (page
103). For Windows computers a special device driver file,
102).
102). Serial port configuration is unnecessary.
102).
Rear panel USB ports
101

Advertisement

Table of Contents
loading

This manual is also suitable for:

Realstor 4005 series

Table of Contents