Expansion Module Detail (J1212/J1224) - Seagate RealStor 5005 Series Hardware Installation

Rear panel components
Controller modules
The top slot for holding IOMs is A and the bottom slot is B. The face plate details of the IOMs show the modules aligned
for use in A. In this orientation, the IOM latch appears at the bottom of the module. It is shown in closed/locked position.
The diagrams below identify ports. See
Figure 10 shows CNC host interface ports that can be configured with 8/16Gb/s FC SFPs; 10GbE iSCSI SFPs; or 1Gb/s
RJ-45 SFPs. See
SAS port
Figure 10 4-port FC/iSCSI controller module detail (5005/4005 Series)
Figure 11 shows SAS host interface ports that ship configured with 12Gb/s HD mini-SAS (SFF-8644) external connectors.
SAS port
Figure 11 4-port HD mini-SAS controller module detail (5005/4005 Series)
Expansion module
Figure 12 shows the IOM used in supported expansion enclosures for adding storage. Ports A/B/C ship configured with
12Gb/s HD mini-SAS (SFF-8644) external connectors.
Figure 12 Expansion module detail (J1212/J1224)
"12Gb/s controller module LEDs" (page 26)
"Install an SFP transceiver" (page 104)
Ethernet
port USB port
Ethernet
port USB port
Serial
port
for installing qualified SFP options in CNC ports.
Serial ports
(service only)
Illustration is under construction
Serial ports
(service only)
SAS ports
for LED identification.
CNC ports
Reset
(typical 2 places)
SAS ports
Reset
(typical 2 places)
Ethernet
port
Enclosure core product 21