Select Sensors For The Measured Value Display; Adjusting The Touch Screen Calibration - Hach sc1000 User Manual

Figure 43 Measured Value Display
Sensor
X.XX

5.1.4.1 Select Sensors for the Measured Value Display

5.1.5 Adjusting the Touch Screen Calibration

网址：www.mamots.com
Time
Unit
Parameter
1. Tap the bottom-left of the screen to display the pop-up toolbar.
2. Select the button to view the device list of currently registered sensors
LIST
and options.
3. Select the
WRENCH
selected measured value display
4. Select the entry in the top list and select the
Measurement Value Display. Select the
Measurement Value Display.
5. Select to accept the selection. The measured value display will appear on the
ENTER
screen. Depending on the number of selected values and the selected screen display
option, the user may need to scroll up or down to see all selected values.
During initial commissioning of the controller, the touch screen calibration will be
automatically displayed. To configure the touch screen, follow the calibration points on
the screen. Make sure that the touch screen is calibrated to the appropriate device (finger,
stylus, etc.) that will be used by all operators. If the device is changed, it will be necessary
to recalibrate the screen.
To recalibrate the touch screen after initial commissioning:
1. From the System Setup Menu, select Display Settings and touch screen Calibration.
2. Follow the calibration points. When calibration is complete the Display Settings menu
will be displayed.
Sensor 1
X.XX
Sensor 3
X.XX
button. The display is split between the full device list and the
(Figure 37 on page
ADD
REMOVE
客服：400 688 9809
Sensor 2
Uhrzeit X.XX
Einheit
Parameter
Sensor 4
Uhrzeit X.XX
Einheit
Parameter
41).
button to move the entry to the
button to delete an entry from the
电话：0431-85178766
Operation
Uhrzeit
Einheit
Parameter
Uhrzeit
Einheit
Parameter
45