Cellular Network Connection; Configuration With Hach Cellular (Telenor) Sim; Configuration With Customer Supplied Sim; Configure The Sensors Or Analog Inputs - Hach SC4500 User Manual

c. WPA2 Enterprise: Authentication for enterprise networks. Enter the enterprise credentials,
User name andWi-Fi password, to access the network.
4. Select APPLY.

6.2.3 Cellular network connection

Note: Only for Claros connection.
The external USB box cellular is necessary to connect the controller to a mobile network. Refer to the
documentation supplied with the USB box cellular for installation instructions.

6.2.3.1 Configuration with Hach Cellular (Telenor) SIM

If the controller connects to the internet with the factory installed SIM card and the default Hach data
plan (Telenor), do the steps that follow:
1. Push the main menu icon, then select Controller > Connectivity > Cellular.
2. Set the Cellular connectivity button to on.
3. Select APPLY.
Note: Make sure that the SIM card is not locked. If necessary, use the SIM PIN setting to enter the SIM card
PIN.
4. After a maximum of 5 minutes, examine the signal strength that shows on the display. The cloud
icon shows a correct connection.

6.2.3.2 Configuration with customer supplied SIM

To change the SIM card and connect the controller to the internet with a cellular network through a
customer supplied data plan, do the steps that follow:
1. Install a user-supplied Micro SIM card. Refer to the documentation supplied with the USB box
cellular for more information about the cellular network installation.
Note: Follow all the cellular manufacturer recommendations and guidance.
2. Push the main menu icon, then select Controller > Connectivity > Cellular.
3. Make sure that the Cellular connectivity button is set to on.
4. Enter the settings.
Option Description
Provider Sets the Provider name (Access Point Name). Select Telenor (NA/Verizon network) for the
default settings or Other to set a provider.
APN Shows the provider name. When Other is selected on the Provider setting, enters the
name of the provider.
SIM PIN SIM card PIN
User name User name
Password User password
Internet sharing Set to on to share the internet connection with other controllers
5. Select APPLY and wait until a confirmation message shows on the display.
6. After a maximum of 5 minutes, examine the signal strength that shows on the display. The cloud
icon shows a correct connection.

6.3 Configure the sensors or analog inputs

The controller is supplied with two digital SC connectors based on the controller configuration. Refer
to Figure 6 on page 13. Use the digital SC connectors to connect digital sensors to the controller.
To connect an analog sensor or analog input to the controller, remove one of the digital SC
connectors and install the applicable expansion module. Refer to the documentation supplied with
the expansion module.
English 27