Using The Menu Windows; Navigating The Menu Windows - Hach sc1000 User Manual

Operation

5.1.3 Using the Menu Windows

Figure 38 Main Menu
1
1. Display Area
2.
BACK
3.
FORWARD
4. –confirms the entry or selection.
ENTER
5. –changes to the display of measured values. The pop-up toolbar cannot open from the menu window. To view the
HOME
Main Menu from this display, touch the Home button and then the bottom of the screen.
6. –scrolls up
UP
7. –scrolls down
DOWN

5.1.3.1 Navigating the Menu Windows

网址：www.mamots.com
42
If the Menu button (from the pop-up toolbar) is selected, the Main Menu screen is opened.
The Main Menu screen allows the user to view the sensor status, configure the sensor
setup, system setup, and perform diagnostics. The menu structure may vary depending
on the configuration of the system.
2 3
MENU
SENSOR STATUS
SENSOR SETUP
SYSTEM SETUP
TEST/MAINT
To view a menu item, touch the menu item or use the
item. The menu item remains highlighted for approximately 4 seconds after it is selected.
To view the highlighted command, select the area to the left of the menu item or select the
button.
ENTER
A "+" next to a menu command indicates there is a submenu. Touch the "+" to view the
submenu. An "i" next to a menu command indicates it is information only.
If a menu item is editable, highlight the item and touch the far-left part of the menu item
until it is highlighted and press
displayed to change an entry
(Figure 41 on page 44).
Messages are displayed in the message window
4 5
UP
or double-tap the highlighted item. A keypad will be
ENTER
(Figure 40 on page 43) or a list box will be displayed
(Figure 42 on page
客服：400 688 9809
6
7
and keys to highlight the
DOWN
44).
电话：0431-85178766