Controller Display Features; Important Key Presses - Hach sc100 User Manual

Operation

4.2 Controller Display Features

Figure 24 Display Example
1
2
3
1. Status bar. Indicates the sensor name and status of relays. The relay
letter is displayed when the relay is energized.
2. Main measurement
3. Secondary measurement (if applicable)

4.2.1 Important Key Presses

MAIN MENU
SENSOR DIAG
SENSOR SETUP
SYSTEM SETUP
TEST/MAINT
30
When a sensor is connected and the controller is in measurement mode, the controller
automatically identifies the connected sensors and displays associated measurements.
The display will flash on startup, when a sensor error has occurred, when the hold outputs
function has been activated, and when a sensor is being calibrated. An active system
warning will cause the warning icon (a triangle with an exclamation point inside) to be
displayed on the right side of the display. See
SENSOR NAME:
7.00
TEMP: 23.0°C
• Press then
HOME RIGHT
connected. Continue to press
options:
• Press and
UP DOWN
to display the secondary measurement (temperature) and output information.
SENSOR NAME:
7.00
TEMP: 23.0°C
• When in Menu mode, an arrow may appear on the right side of the display to indicate
that more menus are available. Press
direction) to display additional menus.
SYSTEM SETUP
OUTPUT SETUP
RELAY SETUP
NETWORK SETUP
DISPLAY SETUP
Figure
pH
4. Parameter
5. Warning icon area
6. Measurement units
or to display two readings when two sensors are
LEFT
or
RIGHT LEFT
to toggle the status bar at the bottom of the measurement display
SENSOR NAME:
pH pH
7.00
pH pH
OUTPUT1: 12.00 mA
or
UP DOWN
SYSTEM SETUP
DISPLAY SETUP
SECURITY SETUP
LOG SETUP
CALCULATION
24.
to toggle through the available display
SENSOR NAME:
pH
7.00
pH
OUTPUT2: 12.00 mV
(corresponding to the arrow
SYSTEM SETUP
SECURITY SETUP
LOG SETUP
CALCULATION
ERROR HOLD MODE
4
5
6