Connecting Sensors To The Sc1000; Connecting The Sensor Data Cable; Adding Sensor Connections - Hach sc1000 User Manual

Hide thumbs Also See for sc1000:

Table of Contents

3.12 Connecting Sensors to the sc1000

Figure 32

Removing the Protective Cover

网址：www.mamots.com

All sc series sensors can be used on the sc1000.

Important Note: Plan the route for the sensor cable and lay the data and power cables so

that they do not cause a trip hazard and the cables do not have any sharp bends.

For details on the installation and operation of the sensor, refer to the appropriate sensor

manual.

1. Unscrew the protective cover on the controller socket

protective cover. When you remove the sensor, re-fit the protective cover.

2. Align the connector plug with the socket, pay attention to the orientation of the

connector lugs.

3. Hand-tighten the union nut.

Note: Do not use the middle connection for the sensors, this is reserved for the display module

(Figure 8 on page

15).

When all sensor connectors on the sc1000 controller systems are already in use for

sensors, more sensor connectors can be added (max. 8 sensor connectors). It may be

necessary to remove an existing expansion card if accessibility to sensor connectors is

obstructed (refer to

Removing an Expansion Card on page

Note: If a probe module has the maximum number of sensors, more sensors may be added to the

system by purchasing additional probe modules.

1. Remove power from the instrument. Open the probe module cover.

2. Remove the fitting or plug from a spare sensor socket hole.

Installation

客服：400 688 9809

(Figure

32). Retain the

30).

电话：0431-85178766

Table of Contents