Hach sc1000 User Manual page 64

Compliance Information
FCC PART 15, Class "A" Limits
网址：www.mamots.com
64
Supporting test records by WE-EM Nachrichtentechnik GmbH German Test Center and
certified compliance by Hach Company.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense. The following techniques of
reducing the interference problems are applied easily.
1. Disconnect the Model sc1000 Probe and Display Modules from it's power source to
verify that it is or is not the source of the interference.
2. If the Model Model sc1000 Probe and Display Modules is connected into the same
outlet as the device with which it is interfering, try another outlet.
3. Move the Model Probe and Display Modules away from the device receiving the
interference.
4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
客服：400 688 9809
电话：0431-85178766