Console; Console Adjustment (4600 Pt/Cl); Poly-V And Htd Belt - Stairmaster FreeClimber 4600 PT Owner's Manual

PARTS REMOVAL AND REPLACEMENT

CONSOLE

1. Remove the four mounting knobs from the back of the console.
2. Disconnect the main cable, contact heart rate cables (4600 PT/CL), and
®
Polar cable (4600/4400 PT/CL) from the back of the console. Lift
the console off the machine.
3. Reverse the steps to reinstall the console.
CONSOLE ADJUSTMENT
1. Loosen the console bracket wing nut.
2. Pivot the console up or down to adjust the
console to desired viewing angle and then
tighten the wing nut.

POLY-V AND HTD BELT

THE BELTS MUST BE PROPERLY TENSIONED. A BELT THAT IS TOO TIGHT WILL
CAUSE SLOW AND SLUGGISH OPERATION. A BELT THAT IS TOO LOOSE WILL
1. Remove the bottom cover.
2. Loosen the adjustment bolt that mounts the alternator to the
slotted alternator brace and the pivot adjusting bolt and nut. Swing the
alternator down.
3. Remove the Poly-V belt.
4. Slide the HTD belt toward you and off the HTD pulley. Remove the
belt from the machine.
5. Reinstall the HTD belt.
Page 50
!
WARNING
CAUSE EXCESSIVE NOISE AND BELT WEAR.