Hach D3433B8.99 User Manual page 18

Event
The sample calibration is completed.
The zero calibration was started.
The zero calibration is completed.
Section 7 Replacement parts and accessories
Personal injury hazard. Use of non-approved parts may cause personal injury, damage to the
instrument or equipment malfunction. The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the appropriate distributor or refer to
the company website for contact information.
Consumables
Description
Conductivity reference solution, 100 µS/cm
Conductivity reference solution, 500 µS/cm
Conductivity reference solution, 1000 µS/cm
Conductivity reference solution, 1990 µS/cm
Parts and accessories
Description
Conductivity module for SC4500 Controller
sc digital gateway for contacting conductivity sensor
Fitting, compression, ½-inch PVDF
Fitting, compression, ¾-inch PVDF
Fitting, compression, ½-inch 316 stainless steel
Fitting, compression, ¾-inch 316 stainless steel
1
Flow chamber , low-volume, PVDF
1
Flow chamber , low-volume, 316 stainless steel
Gasket, EDPM, for 1½-inch sanitary sensors
Gasket, EDPM, for 2-inch sanitary sensors
Gasket, FPM/FKM, for 1½-inch sanitary sensors
Gasket, FPM/FKM, for 2-inch sanitary sensors
Sanitary clamp, 1-½-inch heavy duty
Sanitary clamp, 2-inch heavy duty
1
For use with a 0.05 cell constant sensor only. Sample volume is limited to approximately 20 mL.
18 English
Table 7 Event list (continued)
Description
End of calibration for conductivity
Start of zero calibration
End of zero calibration
W A R N I N G
Quantity
1 L 25M3A2000-100
1 L 25M3A2000-500
1 L 25M3A2000-1000
100 mL
LXZ525.99.D0004
6120700
1000F1236-111
1000F1236-122
1000G3316-101
1000A3316-102
Item no.
210542
Item no.
4H1285
4H1135
9H1381
9H1327
9H1383
9H1384
9H1382
9H1132