Hach D3433B8.99 User Manual page 7

Figure 2 Mounting examples
1 Flow-thru T-mount, ¾ or ½-in.
NPT tee
2 Non-metallic sensor, flow-thru T-
mount, ¾-in. NPT
3 Non-metallic sensor, end of pipe
immersion
3.2 Connect the sensor to an SC Controller
Use one of the options that follows to connect the sensor to an SC Controller:
• Install a sensor module in the SC Controller. Then, connect the bare wires of the sensor to the
sensor module. The sensor module converts the analog signal from the sensor to a digital signal.
• Connect the bare wires of the sensor to an sc digital gateway, then connect the sc digital gateway
to the SC Controller. The digital gateway converts the analog signal from the sensor to a digital
signal.
Refer to the instructions supplied with the sensor module or sc digital gateway.
Section 4 Operation
Fire hazard. This product is not designed for use with flammable liquids.
4.1 User navigation
Refer to the controller documentation for the touchscreen description and navigation information.
4 End of pipe immersion
5 Sanitary (CIP) flange mount
6 Boiler wall insertion mount
W A R N I N G
7 Ball valve insertion,
compression-style sensor with
extended sensor body
English 7