Pcie Adapter And Riser Assembly Replacement - Lenovo ThinkSystem SR665 V3 User Manual

Figure 53. Installing the OCP module
a. Push the OCP module into the slot until it is fully seated.
b. Tighten the thumbscrew to secure the module.
Step 4. (Optional) Attach the new OCP label to the rear of the server.
Figure 54. Attaching the OCP label
After you finish
Complete the parts replacement. See

PCIe adapter and riser assembly replacement

Follow instructions in this section to remove and install a riser assembly and PCIe adapter. The PCIe adapter
can be an Ethernet card, a host bus adapter, a RAID adapter, an add-in PCIe SSD adapter, or any other
supported PCIe adapters. PCIe adapters vary by type, but the installation and removal procedures are the
same.
The server supports the following riser cages:
ThinkSystem SR665 V3 User Guide
96
"Complete the parts replacement" on page 164.