Table of Contents
Advertisement
Installation
Birch Log Kit 1505BLKV2
Material required
• Black steel platform (supplied with appliance)
• Birch Log Kit containing:
• 8 logs
• 1 bag of mixed grey embers (6 cup bag)
L30
L2
L12
Note:
Use of this log set may increase the possibility of
soot formation when air shutters are set to the
minimum setting. Although LT1 units are fitted
with a minimum air shutter stopper intended to
prevent sooting with most log sets, it is possible
some sooting may occur when using this log set
and the air shutter is set to minimum position.
Evaluate the flame picture carefully after the unit
has warmed up for fifteen minutes, and avoid
setting the air shutter to minimum when there
is limited rise in the venting system or the flame
appears overly luminous and lazy with smoke
trailing off the flame tips.
Refer to page 56 for the location and function of
the air shutter adjustment lever.
40
L31
L6
L32
L4
L1
Installation
1. Carefully unpack the kit, as the logs are fragile.
2. Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath.
Installed platform
3. Place log L30 with the pin inserted in the hole as
shown. Put the other end of the log gently on the
pilot shield.
L30
4. Place log L2 with the pin inserted in the hole in L30
as shown, across the burner to the front of the
media platform.
L2
L30
Fuel Beds
Advertisement
Table of Contents
