Installation
Birch Log Kit 1000BLKV2
Material required
• Birch Log Kit, which contains:
• 10 logs
• 2 cups of embers, bagged
• Gloves, if desired
H1
H2
G5
G4
Installation
Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have pegs
to help you place them on the burner platform, or other
logs.
Install the logs as shown below.
1. Place log H11 into the right hole in the front of the
burner cover. Note the angled feature of H11 should
be pointed to the right side.
22
G3
H7
H11
H13
H10
H9
H11
2. Place log H10 into the left hole in the front of the
burner cover.
H10
3. Place log H1 onto the rear support bracket, and slide
it as far to the right as it will travel, gently resting the
log against the pilot shield.
H1
4. Place log G4 directly on the burner, its underside
groove fi tting on the front raised fl ange of the
burner. Slide the log all the way to the left.
Fuel Beds
H11
G4
H1
G4