Fuel Beds; Traditional Log Set Mf28Lsk - Valor MADRONA MF28JN Installation Manual

Installation

Traditional Log Set MF28LSK

Material required
• Traditional Log Set containing:
• 6 logs
• Gloves, if desired (not included)
Installation
Unpack the ceramic logs very carefully to avoid
damaging their fragile material. Install the logs as
shown below. Please note that the position of the logs
is critical to ensure the good performance of the
appliance.
1. Place the rear log on the sheet metal support. Pull it
forward until the notch in the underside of the log
sits against the front edge of the sheet metal sup-
port. Slide the log towards the left hand side until
the notch in the log touches the right angled return
edge of the pilot shield as indicated.
Rear log pushed to
the left abuts the
pilot shield
2. Place the front left log on the burner. Slide it to-
wards the left until its narrow end rests in the notch
of the rear log as indicated.
3. Place the top left log on the pin of the rear log. The
bottom of the log rests on the left side and of the
front left log just installed.
Note: Make sure the lower end of the top log rests
on the front log as indicated and does not fall below
in the firebox.
Pilot area
This log must
rest ON the
front log
Front log

Fuel Beds

21