Valor LT2 2700K Manual

Concept
1/2 inch thick non-combustible
board –NOT supplied
Remote
Handset
Wall Holder
Mantel—See Mantel &
Hearth Clearances
S S urrou nd d d Plate l l
Barrier Screen (require e d)
1" Trim 2775LFB accepts
additional fi nish (maximum
1/2" thick) over no o n-
combustible board a a nd
behind trim.
2730CIK installs befo o re
non-combustible boa a rd.
Combustible or no o n-
combustible board finish h es
up up up up p p p p p p p to to to to p p p per p p per p per per p ime imeter ime ime ter ter ter of of of of
W W all Finish W W al W W W W W al a l F n s is l Fi sh h h F F in n ini
Combusti ustible wall fi nishes ustib usti e e st t b e w w w a ble b w b e w wa fi fi n l fi n s e e s ni sh s es sh
up to 1" 1" th 1" " thick are allowed 1" th h " thi t c ar a th k h k i k are r e e a e a a l a l l ow ow w d d
over to er top o er to o p of the non- op o o op of p o th h of f t e e h h t e e n n non-
combustib stible b stible board. le b le b e b b b bo o o o a
Combustible mante tel ar nte are
ok provided they conform
to specifi cations in the
Installation Manual
Combustible Floor
Valor Fireplaces • 190—2255 Dollarton Highway • North Vancouver, BC • V7H 3B1
LT2 2700K
w wi i i th h h
e
u
o
a
r
o
a
o
h
tr tr tr trim. r r im. im. im.
s
we e e d
on on
ar d d rd
l are l ar r ar r e e
rm rm
Hearth: not required.
If used,a combustible hearth must be
minimum 4" below fi replace opening.
Tel: 604.984.3496 or 1.800.468.2567 • Fax: 604.984.0246 or 1.800.268.0333
www.valorfi replaces.com
Note: This appliance may be installed in
outdoor, weather protected environments as
defi ned in the GV60CKO Outdoor Conversion
Kit instruction manual.
Combustible Framing Allowed Beneath Fireplace. When the
appliance is installed directly on carpeting, tile or other combustible
material other than wood fl ooring, the appliance shall be installed on
a metal or wood panel extending the full width and recessed depth
of the appliance.
October 2023
1/2
Required HeatShift plenum
(LDK4 pictured)
Required HeatShift piping
Framing—See Framing
Requirements
2700K heater
Remote Battery
and Wall Switch
Kit c/w 35-foot wire
length (supplied)
Electrical junction
box to connect
power when
using lighting or
optional WiFi