Table of Contents
Advertisement
Installation
Ceramic Liner Installation
The liners install in the manner outlined below with the
exception of the 2525RGL—Refl ective Glass Liners:
see instructions supplied with the liners.
Unpack the liner panels carefully.
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors just enough to
allow them to rotate (one per side).
2. Place the rear panel into the fi rebox, left side fi rst,
and angled edge upward.
Front
3. Rest the rear panel behind the three tabs on the
support rail. Support the rear panel with your hand
- it should not tip forward.
38
Rear
4. Place the right panel bottom fi rst, then fl atten to the
wall from front to back. Rotate the anchor down
once the panel is in place.
5. Place the left panel bottom fi rst, then fl atten to the
wall from front to back. Rotate the anchor down
once the panel is in place.
6. Remove the top center bracket (2 screws) and keep
the screws.
Liner Installation
Advertisement
Table of Contents
