Do Not Drill/Screw Areas - Valor LT1 2500KN Installation Manual

Installation Planning
Non-Combustible Finishing Over
Non-Combustible Board
Additional material such as tile, etc.,
may be applied over top of the non-
combustible board or you may choose to
leave it fi nished clean with no tile, etc.
Be aware that a trim is always required.
Finish should not cover the trims.
2575 Trim
Only the 2575 style trim will accept tile,
etc. tucked behind it (up to 5/8" thick for
the 2575).
2530 Trim
2530 trim must be installed BEFORE non-
combustible board. Non-combustible
board and fi nishes are applied to the
perimeter of the trim frame. Non-
combustible board and fi nish CANNOT
be tucked under this trim.

Do Not Drill/Screw Areas

The face of the fi replace must not be
drilled or screwed into as shown below.
These areas house electrical and/or
control elements of the fi replace that
could be damaged and present risk of
injury.
17-1/2" [445 mm] Wide
8-3/4" [222 mm] High
16
Clean Installation Kit (2530) does not adjust
forward. Non-combustible board fi nishes
up to perimeter of the trim. Must be
installed before fi nish.
WARNING
Do not drill or screw in these areas!
Wall Finish
Narrow trim (2575) can adjust up to 5/8"
forward of surface of non-combustible
board
3" [76 mm] Wide
5-1/2" [140 mm]High