Fuel Beds; Install Decorative Glass Murano 700Xdgm - Valor G3.5 Installation Manual

Installation

Install Decorative Glass Murano 700XDGM

Material required
• Decorative Glass Murano kit, which contains:
• 1 glass platform
• 1 glass piece for pilot cover
• 2 platform retainers
• 1 pilot cover
• 1 emberbed cover
• 1 bag of clear fi reglass
• Gloves (recommended to manipulate glass)
Installation
Carefully unpack the kit. Wear
gloves to handle the fi reglass.
1. Install the platform retainers
as indicated.
2. Place the pilot cover on the
ceramic burner over the pi-
lot shield.The lip on the top
surface goes to the front.
3. Place emberbed cover
over front of burner with
tabs into recess part.
4. Install the glass platform
on top of the retainers.
20
5. Carefully spread the glass on top of the burner
within the platform opening.
6. Install the square glass panel on top of the pilot
shield.
NOTE: Ensure the area within the pilot shield is clear
of glass particles.
lip in
front
IMPORTANT: Use only the fi reglass approved for
your Valor fi replace or the fi reglass brands American
Fireglass™ or fi regear. Use of other fi reglass or crushed
glass can damage your fi replace and void the war-
ranty.
WARNING
Choking Hazard! Ensure that the fireplace
area is clear of glass pieces as these could
be ingested by small children. Vacuum
area after installation.
Pilot area

Fuel Beds