Installing A Drive In The Rear Internal Bay - Epson ActionTower 8600 User Manual

4. If you have finished installing or removing drives, replace
the computer's cover; see "Replacing the Cover" in
Chapter 3 for instructions. Then see "Running SETUP" in
Appendix B for instructions on defining your new drive
configuration.

Installing a Drive in the Rear Internal Bay

Your computer may have a hard disk drive already installed in
the rear internal drive bay. If so, you must first follow the
instructions under "Removing a Drive From the Rear Internal
Bay." Then follow the steps below.
Follow these steps to install a drive in the rear internal drive bay:
1. Remove the drive and power cables from the back of any
drive already installed in the rear internal drive bracket.
2. Remove the four screws securing the rear internal drive
bracket to the computer's back panel and slide it out of the
computer.
Installing and Removing Tower Drives
5 - 1 5