Connecting The Cables To The Front Internal Drive - Epson ActionTower 8600 User Manual

Connecting the Cables to the Front Infernal Drive
Follow these steps to connect the IDE device and power cables to
the front internal drive:
1. Locate one of the IDE device cables that are connected to the
IDE interfaces on the system board. They are flat cables with
a system board connector at one end and two IDE device
connectors at the other end. A red wire is on one side of the
cable. (See "Locating the System Board Components" in
Chapter 3 to find the primary and secondary IDE interfaces
on the system board.)
system board connector
Use the primary IDE interface for your boot drive and your
second hard disk drive; use the secondary IDE interface to
connect IDE CD-ROM drives, other IDE devices, or your
third and fourth hard disk drives. You cannot connect a
CD-ROM drive and hard disk drive to the same interface.
2. Identify the IDE device connector you will use on the IDE
device cable.
3. Locate pin 1 on the drive connector. The number 1 or 2 may
be printed on the drive's connector or circuit board to
identify the side of the connector containing pin 1.
red wire
Installing and Removing Tower Drives 5-5
IDE device connectors