Removing Slmms - Epson ActionTower 8600 User Manual

4. Push the SIMM into the socket until it is seated firmly in the
slot. Then tilt it upright, as shown below, guiding the hole at
each end of the SIMM over the retaining post at each end of
the SIMM socket. If it does not go in smoothly, do not force
it; pull it all the way out and try again.
5. Replace any option cards you removed; see "Installing an
Option Card" for instructions.
6. Replace the computer's cover as described under "Replacing
the Cover." Then see "Post-installation Procedures" for
instructions on configuring your computer with your new
memory size.

Removing SlMMs

If you need to remove SIMMs from your computer (to install
different ones, for example), follow the steps below:
1. Use the illustration under "Locating the System Board
Components" to locate the SIMM sockets on the left side of
the system board, next to the processor.
Installing and Removing Options 3-15