Installing A Card In The Slimline Computer (2-Slot Side) - Epson ActionTower 8600 User Manual

Installing a Card in the Slimline Computer (2-slot Side)

The option card connector board in the slimline computer has
two slots on one side and three slots on the other side.
Follow these steps to install an option card on the two-slot side:
1. Remove the retaining screw securing the slot cover bracket.
Remove the bracket by lifting it straight up and out of the
small metal holder at the bottom.
2. Remove the slot cover for the slot you are going to use.
3. Hold the card along the top corners and guide it into the slot.
Once the connectors reach the slot, push the card in firmly
(but carefully). You should feel the card fit into place. If it
does not go in smoothly, do not force it; pull the card all the
way out and try again.
4. Replace the slot cover bracket by inserting it into the small
metal holder below the option slots; then replace its
retaining screw.
5. Replace the computer's cover as described under "Replacing
the Cover." Then see "Post-installation Procedures" for
instructions on configuring your computer with your new
option card.
3-20 Installing and Removing Options
slot cover
t