Installing Memory Modules (Simms) - Epson ActionTower 8600 User Manual

3. To move a jumper from one position to another, use needle-
nose pliers or tweezers to pull it off its pins and gently move
it to the desired position.
Caution
Be careful not to bend the jumper pins or damage any
components on the system board.
4. Replace any option cards you removed, if necessary; see
"Installing an Option Card" for instructions.

Installing Memory Modules (SIMMs)

The computer comes with 8MB of RAM standard on two 4MB
SIMMs. You can increase the memory up to 128MB using 4MB,
8MB, 16MB, or 32MB SIMMs. The SIMMs must be tin-plated,
72-pin, single- or double-sided, fast-page mode or EDO mode,
parity or no-parity type with an access speed of 70ns or faster. Be
sure all the SIMMs operate at the same speed.
The table below lists all the possible SIMM configurations; do
not install SIMMs in any other configuration.
Note
All 4MB and 16MB SIMMs must be single-sided. All 8MB and
32MB SIMMs must be double-sided.
SIMM configurations
Bank 0
SlM1
-
4MB
3-12 Installing and Removing Options
I SIM2 SIM3
I 4MB
-
4MB
4MB
4MB
Bank 1
Total memory
I SIM4
4MB 8MB
4MB 16MB
I