Connecting The Drive And Power Cables - Epson ActionTower 8600 User Manual

4. Align the slots at the side of the drive bay with the mounting
holes in the drive or mounting frames. Then secure both
sides of the drive to the bay using the retaining screws that
came with the drive.

Connecting the Drive and Power Cables

If your IDE device cable is already connected to the IDE
interface, follow the steps in this section to connect the cable to
the drive.
Note
Make sure you connect a CD-ROM drive to the secondary IDE
interface; do not use the same cable for a hard disk drive and a
CD-ROM drive.
Follow these steps to connect the drive and power cables:
1. Locate the connector at the end of the ribbon cable.
2. Locate pin 1 on the drive connector next to the power
connector.
Installing and Removing Slimline Drives
4 - 1 8