Installing A Card In The Slimline Computer (3-Slot Side) - Epson ActionTower 8600 User Manual

When you unpack the option card, do not touch the
components on the circuit board or the gold-edged
connectors. Place the card gently on top of its original
packing material with the component side facing up. Keep
the packing materials in case you remove the card later.
Adjust any switches or jumpers on the card, if necessary,
before you install it. (See the option card instructions.)
If you install a video adapter on an option card, you need to
change the setting of jumper JP21 on the system board to
disable the built-in VGA controller; see "Changing the
Jumper Settings" for instructions.

Installing a Card in the Slimline Computer (3-slot Side)

The option card connector board in the slimline computer has
two slots on one side and three slots on the other side. Although
the illustration shows an ISA card, you can use the same
instructions for installing a PCI card.
Follow these steps to install an option card on the three-slot side:
1. Remove the retaining screw securing the option slot cover to
the computer, as shown below. (Keep the screw to secure the
option card to the computer.)
2. Slide out the slot cover and set it aside. (Store it in a safe
place in case you remove the option card later.)
Installing and Removing Options
3-18