Epson ActionTower 8600 User Manual page 113

4. Replace the bracket as shown below and secure it to the back
panel with the four screws you removed earlier.
5.
If there is a drive installed in the rear internal bracket, follow
steps 6 through 8 under "Installing a Drive in the Rear
Internal Bay" to reconnect the drive and power cables to the
drive.
6.
If you have finished installing or removing drives, replace
the computer's cover; see "Replacing the Cover" in
Chapter 3 for instructions. Then see "Running SETUP" in
Appendix B for instructions on defining your new drive
configuration.
5-22 Installing and Removing Tower Drives