Table of Contents
Advertisement
4.
If you removed the only IDE device connected to the
interface the device used, you may want to disconnect the
device cable from the interface on the main system board
and remove it from the computer.
5.
If you have finished installing or removing drives, replace
the computer's cover, as described under "Replacing the
Cover" in Chapter 4. Then see "Using the Fixed Disk Setup
Option" in Chapter 2 for instructions on defining your new
drive configuration.
Installing a Drive in the Rear Internal Bracket
Your computer has a hard disk drive installed in the rear
internal drive bracket. Follow these steps to install a second
drive in this bracket:
1.
Remove the drive and power cables from the back of any
drive already installed in the rear internal drive bracket.
2.
Remove the four screws securing the rear internal drive
bracket to the computer's back panel and slide it out of the
computer. Make sure you save the screws.
Installing and Removing Tower Drives
6-17
Advertisement
Table of Contents
