Epson ActionTower 8600 User Manual page 101

4. Slide the drive into the front of the bay and secure it to the
bay using the four screws that came with the drive.
5. Connect the appropriate cable to the drive.
If you are installing an IDE device, see "Connecting the
Cables to the Front Internal Drive" for instructions on
connecting the drive cable to the drive.
If you are installing a diskette or tape drive, use the
appropriate connector on the diskette drive cable. If your
drive has a connector containing pins (a header connector),
be sure to align pin 1 of the drive connector with the side of
the cable containing the red wire. If your drive has a card-
edge connector (with gold contacts on each side of a flat
plastic connector), align the key-way in the cable connector
with the gap in the drive connector.
If you are installing another type of drive, see the
documentation that came with it for instructions on
connecting its drive cable.
5-10 Installing and Removing Tower Drives