Setting The Voltage Selector Switch - Epson ActionTower 8600 User Manual

Setting the Voltage Selector Switch

Your system is powered by a 200 watt power supply. The power
supply input voltage is controlled by a switch on the computer's
back panel that may be set to 115 VAC or 230 VAC.
The computer is shipped with the voltage selector switch set to
115 VAC, which is appropriate for line source voltages between
100 and 120 VAC. This is generally the correct setting if you use
the computer in North America, South America, or Japan.
If you plan to operate the computer in the United Kingdom,
Europe, or some Latin American countries, you will almost
certainly need to reset the voltage selector switch to 230 VAC.
Line source voltages between 200 and 240 VAC are acceptable
with the switch set to 230 VAC.
Caution
Before you turn on the power to your system, make sure the
voltage selector switch is set appropriately for the electrical
power source in your location or you will seriously damage your
system.
To change the voltage selector switch setting, slide the switch to
the right to select 115 VAC or to the left to select 230 VAC.
1-2 Setting Up Your System