Routing The Iso-Can Bus Harness - Toro 138-6246 Installation Instructions Manual

9
Routing the ISO-CAN Bus
Harness
Parts needed for this procedure:
1 ISO-CAN bus harness—302 cm (119 inches)
12 Cable ties
Identifying the GeoLink Navigation
Cable Type
1. Look at the type of cover over the navigation
cable of your GeoLink system.
Figure 27
1. Braided cover
2. Record the type of navigation cable cover here:
g309467
2. Convoluted-tube
Removing the Terminating
Resistor Harness
GeoLink Navigation Cable with a Braided
Cover
1. Tilt the passenger seat forward and secure it
with the prop rod.
2. Remove the 2-pin and 4-pin connectors of the
terminating-resistor harness from the 2-socket
connector (switched power) and 4-socket
connector (labeled CAN 1/ISOBUS) of the
GeoLink harness
1. 2-socket connector
(switched
power—GeoLink harness)
2. Connectors
(terminating-resistor
harness)
17
(Figure 28).
Figure 28
3. 4-socket connector
(labeled CAN
1/ISOBUS—GeoLink
harness)
g309471
g309468