Table of Contents
Advertisement
9
Routing the Blower Belt into
the Blower Assembly
Parts needed for this procedure:
1
Blower belt
1
Spring
Procedure
1. Install the belt around the blower pulley
2. Install the spring to the idler arm and the peg on the
blower assembly
(Figure
Figure 14
1. Idler pulley
2. Mower deck pulley
3. Spring
(Figure
14).
14).
4. Peg
5. Belt
6. Blower pulley
10
Installing the Blower Assembly
Parts needed for this procedure:
1
Blower assembly
Procedure
WARNING
An uncovered discharge opening could allow
the mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
• Never operate the lawn mower unless you install
a cover plate, a mulch plate, or a grass chute and
catcher.
• Make sure the grass deflector is installed when
the grass chute and catcher are removed.
1. Remove the side discharge chute from the mower deck
(Figure
15).
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Slide the blower assembly peg into the pivot hole
(Figure
16).
12
Figure 15
5. Spring installed
6. Grass Deflector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring
Advertisement
Table of Contents
