1
Preparing the Machine
No Parts Required
Procedure
CAUTION
Chemicals are hazardous and can cause
personal injury.
• Read the directions on the chemical labels
before handling the chemicals and follow
all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin.
Should contact occur, wash the affected
area thoroughly with soap and clean water.
• Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Ensure that the tires are aligned straight ahead.
4.
Shut off the engine and remove the key.
5.
Wait for all movement to stop before leaving the
operator's seat.
6.
Clean the sprayer; refer to Cleaning the Sprayer
in the Operator's Manual for the machine.
7.
Allow the machine components to cool.
2
Verifying the Software
Version
No Parts Required
Procedure
1.
Turn the ignition key to the R
/
(diesel) position.
PREHEAT
RUN
2.
Press the A
BOUT
corner of the control console
(gasoline) or
UN
(Toro) icon at the upper left
(Figure
1).
1. A
(Toro) icon
BOUT
2. A
fly-out-window
BOUT
3.
When the software version is correct, the About
dialog box displays software version 4.04 or
higher.
Note:
If the software versions differ, contact the
Toro technical assistance center.
3
Preparing the Laptop
Computer
No Parts Required
Downloading PVED CLS Firmware
Release Package
1.
Access www.danfoss.com.
2.
Access the PVED CLS web page.
3.
In the
DOWNLOADS
2.00 firmware release package to your laptop
computer.
4.
On your laptop computer, extract the PVED CLS
2.00 firmware release package.zip file.
5
Figure 1
3. Software version number
(version 4.04 or higher)
list, download the PVED CLS
g302935